The
choice of buffer for HPLC method development is significant since it can impact
on the HPLC isolation. It is significant that the buffer has a pKa close to
the preferred pH as the buffers best control the pH at their pKa.
To make
an aqueous mobile phase is the most important stage of RP-HPLC method
development for ionic molecules. This contains a consideration of the effects of
pH on the retention time of a component, concentration, and type of buffer,
solubility and its effect on detection. Inappropriate selection of buffer, in
terms of pH, ionic strength, and buffering species may result tailing and
irreducible retention time of polar and ionizing compounds in the
reversed-phase separation.
Complexities such as interactions between molecules
and partial ionization, molecules and other active sites on stationary phases
can be conquered by selecting the appropriate buffer its correct ionic species
and ionic strength in the mobile phase. In separations LC-MS that rely too much
on the correct choice of acid, base, buffering species, and other additives, a
buffer have to be selected based on its ability to suppress and not inhibit the
ionization of the molecule at the MS interface. The retention time of ionic
components in reversed-phase chromatography is fundamentally influenced by
the pH of the mobile phase. The RT of non-ionic components is minimum affected by
the pH of the mobile phase.
Buffer
is a solution of a weak base and its conjugate acid or weak acid and its
conjugate base. They reduce the effect of hydroxide and hydrogen ions and
reduce pH fluctuations upon the dilution. Usually, the range of pH is 2.00 to
8.00 for RP-HPLC on silica-based packing. The selection of a buffer solution is
usually governed by the preferred pH. If the pKa close to the pH then the
buffers best control the pH. The most commonly used buffer systems for
reversed-phase chromatography are phosphoric acid and its potassium or sodium
salts, acetate buffers, which are also frequently used for separation.
The
phosphate buffer is ideal for most HPLC separations, as it has two pKa values,
(2.1 and 7.1) and UV transparency. But the use of phosphate buffer in LC-MS is
not appropriate, it prefers volatile buffer systems i.e. Acetate, TFA, ammonia,
and formate, etc.
Buffer
Concentration: A higher
the concentration of the buffer that increases the buffer capacity will give a more
reproducible separation of partially ionized analytes at the pH of the mobile
phase, typically, a buffer concentration of 10 to 50 mM is sufficient for
separation of components. A highly concentrated buffer will cause a high
backspace for the system.
Buffer
pH: The retention time of
ionic components in reversed-phase chromatography are basically affected by the pH of the mobile phase as compared with non-ionic components. In general, the
pH range of buffer solution or mobile phase for RP-HPLC is 2.00 to 8.00. The
selection of buffer solutions is usually controlled by the preferred pH.
Effects
on Detection:
The
selection of buffer is also reliant on the means of detection. For conventional
UV/VIS detector, the buffer solution must be transparent, effectively in this
range, particularly important for gradient elution separation.
Buffer
Solubility:
This is
particularly significant while working with the gradient elution method. The
solubility can be determined empirically by mixing the specified volume
fractions of the organic solvent and the buffer solution. The presence of precipitates
solutions specifies that the solubility issues with the solute and mobile
phase or solvent. A general rule is that the organic phase should not exceed 50%,
which should be used with the buffer.
You may also like this
No comments:
Post a Comment